National Level Online Quiz on Engineering Workshop
National Level Online Quiz on Engineering Workshop Organized By Department of Mechanical Engineering, Bharat Institute of Engineering and Technology, Hyderabad, Telangana.
After Quiz Completion Everyone Will Receive A Participation Certificate On Your Email Id.
Here You can sell all the questions which are asked in this quiz competition
1. The teeth of hacksaw blade are bent
Towards right
Towards left
Alternately towards right and left and every third or fourth left straight
May be bent in any direction
2. The cross-section of a chisel is usually
Rectangular
Square
Hexagonal
Octagonal
3. A file removes the metal during
Forward stroke
Return stroke
Both forward and return strokes
None of these
4. Riddle is used for
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Moistening the sand around the edge before removing pattern
Reinforcement of sand in the top part of moulding box
5. The purpose of a gate is to
Delivers molten metal into the mould cavity
Act as a reservoir for the molten metal
Feed the molten metal to the casting in order to compensate for the shrinkage
Delivers molten metal from pouring basin to gate
6. A mortise gauge is a
Striking tool
Planing tool
Boring tool
Marking tool
7. Green sand is a mixture of
30% sand and 70% clay
50% sand and 50% clay
70% sand and 30% clay
90% sand and 10% clay
8. The dowels are
Wooden nails
Box nails
Wire nails
None of these
9. The type of file used for a wood work is
Single cut file
Double cut file
Rasp cut file
Any one of these
10. The acetylene cylinder is usually painted with
Black colour
White colour
Maroon colour
Yellow colour
11. V-block is used to
Check the trueness of flat surfaces
Locate centres of round rods
Check the surface roughness
None of these
12. A file with 20 teeth in 25 mm is called
Rough file
Bastard file
Second cut file
Smooth file
13. When a pattern is made in three parts, the top part, is known as a
Drag
Cheek
Cope
None of these
14. The purpose of a riser is to
Deliver molten metal into the mould cavity
Act as a reservoir for the molten metal
Feed the molten metal to the casting in order to compensate for the shrinkage
Deliver the molten metal from pouring basin to gate
15. Which of the following material can be used for making patterns?
Aluminum
Wax
Lead
All of these
For Answers of These Questions You Can Watch This Video
For Participating in This Quiz : Click Here
0 Comments